MT408 - AC-Current Transducer
Properties
- Sinusoidal AC current measurements
- Current range measurements up to 6 A
- Galvanic insulation between input and output
- Accuracy class 0.5
- Self powered
- Housing for DIN rail mounting
Application
MT408 is intended for measuring and monitoring singlephase electrical power network. Current input is electrically insulated from the system by means of current transformer. The signal is rectified, smoothed and amplified into a DC current output.
The MT408 current transducer is used for a permanent monitoring of a single-phase current value. PLCs, PCs, microprocessor control, indicators, alarms units etc. can be operated by the output signal. Current input can be connected either directly to low-voltage network or shall be connected to network via a corresponding current transformer (with standard 1 A or 5 A output).
Technical Data
Input | Output | |||||||||||||||||||||||||||||||||
|
The output may be either short or open-circuited. It is electrically insulated from all other circuits |
Standard nominal input current (IN) |
1A, 5 A or 6 A |
Measuring range limit values |
0 ... 0.5 A to 0 ... 6 A |
Overload capacity: |
acc. to EN 60688 |
Max. measured value (cont.) |
1,2 × IN |
Max. allowed value |
20 × IN ; 1 s, 10 times, 300s interval |
Nominal frequency (fN) |
50, 60 Hz |
Measuring frequency range |
45 … 65 Hz |
Consumption |
< 2 VA |
Messgröße (UN) | Anzahl der Messungen | Dauer einer Messung | Pause zwischen zwei Messungen |
1.2 x IN | - | dauernd | - |
2 x IN | 5 | 1 s | 300 s |
Analog Ausgang
- Stromausgang, IOutN (Ausgangsbereichsendwert):
Bereichswerte: 0…5 mA, 0…10 mA oder 0…20 mA - Bürdenspannung: 15 V
- Einstellzeit: < 300 ms
- Restwelligkeit: < 1 % p.p.